₹6,999.00
Important Notes
Project Code : PF_RFID_2
1.This project we have done on Arduino uno microcontroller
2.Same project possible on ESP32 and raspberry pi pico controller
3.Boxes not included in project
4.Along with project we will provide
a. original code
b. circuit diagram
c. Documentation data
5.This project IEEE reference titles
a. Smart Automatic Petrol Pump System Based on RFID and ESP8266
Rfid Based Petrol Pump Automation System
AIM:
Design and development of RFID based petrol pump automation system.
PURPOSE:
Normal petrol pumps are manual type. Vehicle holders need to interact with operator. Converting these into automation helps to vehicle holders and saving time. By removing manual power we can decrease maintenance cost. Here we proposed solution like RFID based petrol pump automation system.
DESCRIPTION:
RFID reader (EM-18) Interfaced to Arduino through UART interfaces. AC pump operated by relay which is connected to Arduino digital pin. 4X4 matrix keypad connected to Arduino digital pins.
WORKING:
In this project initially we have to swipe RFID card and need to enter password. If password is correct then it asks amount. After entering amount pump will ON and fuel will dispense according to amount. For wrong password buzzer will be ON. Amount will reduced from RFID card based on entered amount. For insufficient amount buzzer will be ON. All this information will be displayed on 16X2 LCD display.
TECHNICAL SPECIFICATIONS:
HARDWARE:
Microcontroller : Arduino Uno
Crystal : 16 MHz
LCD : 16X2 LCD
RFID reader : EM-18
Relay : 12V DC
Pump : 230V AC submersible
Power Source : 12v 2 amp Adaptor
SOFTWARE:
Arduino IDE
Proteus based circuit diagram
APPLICATIONS:
- Petrol Pumps
- Fuel filling stations
INTERFACES COVERD:
- We have covered RFID (EM-18) module interfacing
- 4×4 matrix keypad interface
- AC pump along with relay
Reviews
There are no reviews yet.